DT-112 Pocket DMM
DT-112 is a pocket size DMM. It combine 5 functions with data hold, MAX hold and auto-ranging, conformance to the IEC61010-1, CAT II 600V Pollution degree II, CE Approved.

 

 

Features:

1.2000 counts digit LCD display
2. Relative mode
3. Auto-ranging
4. Data hold, MAX hold, power off and low battery indication

MAX Hold
To hold the highest reading on the LCD, press the MAX hold button. The MAX hold button is located on the left side of the meter (bottom button). The meter reading will not change as readings change, rather it will only display the highest reading encountered since the MAX hold button was pressed. Press the MAX hold button again to return to normal operation.

Manual Ranging
The meter turns on in the autoranging mode. Press the Range button to go to manual ranging. Each press of the range button will step to the next range as indicated by the units and decimal point location. Press and hold the Range button for two seconds to return to autoranging. Manual ranging does not function in the Diode and Continuity check functions

Data Hold Button
The Data Hold function allows the meter to “freeze” a measurement for later reference
Press the “DATA HOLD” button to “freeze” the display, the “HOLD” indicator will appear.
Press the “DATA HOLD” button to return to normal operation.

Auto Power Off
The auto off feature will turn the meter off after 15 minutes.

 

 

Specifications:

Diode Test	Test current 1mA max., open circuit voltage of 1.5V typical
Continuity Check	Audible signal if the resistance is < 150W
Display	2000 count 3-1/2 digit LCD
Over range indication	LCD displays “OL”
Polarity	Minus (-) sign for negative polarity.
Low Battery Indication	“BAT” symbol indicates low battery condition.
Battery	CR2032 3V Lithium
Operating Temperature	32ºF to 104ºF (0ºC to 40ºC)
Storage Temperature	14ºF to 122ºF (-10ºC to 50ºC)
Weight	1.7oz (50g)
Size	4.25x2.2x.5” (108x56x11.5mm)